Using The Bl97 / Em617 - brondell SWASH BL97 Manual Del Propietário

OPERATING THE SWASH

Using the BL97 / EM617

NOTE: The wash functions will not work
unless the sensor in the seat detects someone
sitting down (with the built-in skin conductivity
sensor). To override the Seat Sensor, please
see the instructions on page 18.
Prepare for Wash
Sit on the seat to ensure skin-to-seat contact on
the Seat Sensor.
Warm Water Wash
When ready to wash, touch Rear Wash, Front
Wash, or Strong Wash on the remote one time
to initiate a wash. The nozzle will self-clean,
extend into the toilet bowl, spray for two
minutes, turn off automatically, retract, and
self-clean once again.
1. Touching Rear Wash, Front Wash, or Strong
Wash a second time while the wash is
running will cause the nozzle to oscillate
forward and backward, providing a wider
range of wash spray. Touch again to cancel
the Move function.
2. While washing, users can adjust the water
temperature, pressure, and nozzle position
settings, as well as initiate the Pulse feature
by following the notes on page 15.
3. If you would like to stop the wash before
the two-minute cycle ends, touch Stop to
discontinue water flow.
4. After extended use the water may decrease in
temperature if a Low, Medium, or High water
temperature setting is selected. To regain
warmer water, stop all wash functions for three
minutes to allow the bidet to reheat the water.
Warm Air Dryer Function (EM617 model only)
Touch Dry to activate the Warm Air Dryer.
18
The dryer will run for two minutes and turn
off automatically.
1. While the air dryer is operating, users
can adjust the dryer temperature to a
comfortable level using Dry Temp "+" and
"–" . The dry temperature will be reflected
on the five indicator LEDs.
2. If you would like to stop the dryer before the
two minutes has elapsed, touch Stop.
Gentle Mode
All settings within Gentle Mode are 40%
softer than standard wash modes.
Once activated, gentle mode will begin a
two-minute wash including:
• Full nozzle extension
• Water Pressure set to low
• Front Wash for one minute, Nozzle
Oscillation for 30 seconds, then Pulse
for 30 seconds
After the wash cycle is over, Gentle Mode will
initiate a two minute Warm Air Dry cycle on
Level Two (EM617 model only).
NOTE: While the Gentle Mode cycle is running,
the Water Pressure setting is adjustable. Dryer
settings are also adjustable during the Gentle
Mode (EM617 model only).