RS Pro RSDS1000CFL Serie Inicio Rápido página 12

Function Inspection
DEFAULT
1. Press
SETUP
setup.
2. Connect the ground alligator clip of the probe to the Ground
Terminal on the front panel.
3. Use the probe to connect the CH1 Input Terminal and theCompensation Sig
nal Output Terminal on the front panel.
4. Press "AUTO".
5. Observe the waveform on the screen. In normal condition, the
display should be a square waveform as shown in the below:
6. Test the other channels in the same method. If the actual square
waveforms does not match that in the figure above, please
perform "Probe Compensation".
Note: To avoid electric shock when using the probe, please firstly
make sure that the insulated wire of the probe is in good
condition, and do not touch the metallic part of the probe
when it is connected to a high voltage.
12
to restore the oscilloscope to its default