Pump Reassembly - Simer 3515C Manual Del Usuario

Maintenance
Figure 24 – Hold Shaft
3027 0997
Figure 25 – Assemble Pump
For parts or assistance, call Simer Customer Service at 1-800-468-7867
10. Hold motor shaft with 7/16" open end wrench on shaft flats (Figure 24)
and screw impeller onto shaft. Be sure you do not touch capacitor
terminals with finger or any metal object. Tightening impeller will
automatically locate seal in correct position.
11. Replace impeller screw (if used) by turning counterclockwise (left-hand
thread) into end of shaft.
To avoid electrical shock
12. Remount diffuser on seal plate with two screws.
hazard, use insulated-
handle screwdriver to
13. Follow instructions under Pump Reassembly.
short capacitor terminals
739 0993
as shown.

Pump Reassembly

1. Clean gasket surfaces on pump body and seal plate; install new gasket.
2. Slide motor/seal plate assembly into pump body. Secure with capscrews
(Figure 25).
3. Replace base mounting bolts.
4. Replace motor wiring; replace drain plug.
5. Prime pump according to instructions. See Operation.
6. Check for leaks.
12