Attaching The Fan Blades - Kichler Lyndon Manual De Instrucciones

ATTACHING THE FAN BLADES

NOTE: Before continuing , make sure the power is disconnected by turning o
the circuit breaker of removing the fuse at the circuit box.
Step 1. Position the blade over the blade arm with threaded posts showing.
Make sure the bottom edge of the blade is fully seated against the blade arm.
With a Phillips screwdriver, start a screw into the blade arm (do not tighten)
and repeat for the 2 remaining blade screws . Tighten each screw securely
starting with the center screw. Make sure the blade is straight.
Repeat steps for the remaining blades. (Fig. 19)
Step 2. Fasten blade assembly to the holes located on the bottom of the
flywheel. Tighten the two "pre- installed" motor screws in the blade arm.
Repeat steps for the remaining blades assemblies. (Fig. 20)
Blade Screw
Blade Arm
Motor Body
Flywheel
Motor Screw
Blade Arm
52" Lyndon Patio LED TM
Blade
13