Installation - Tripp-Lite B004-HUA4-K El Manual Del Propietario

Installation

Refer to the following steps and diagram to set up your KVM switch installation.
Note: Before making any connections, make sure that power to all devices being connected to the KVM switch is turned off. Unplug the
power cords of any computers that have the Keyboard Power On function.
7
1
Connect a monitor, USB keyboard and mouse, a microphone, and speakers to the console ports on the back panel of the
KVM switch.
2 Optional – An additional set of speakers and a microphone can be connected to the ports on the front panel of the unit.
Note: The audio ports on the front panel have priority over those on the back of the KVM.
3 Optional – Connect your USB device(s) to the USB 2.0 hub port(s) on the front and back of the KVM switch.
4 Connect the end of the HDMI/USB KVM Cable Kit that includes the USB Type B Male connector to an available set of
computer ports on the back panel of the unit.
5 Connect the other end of the HDMI/USB KVM Cable Kit to the corresponding ports on the computer you wish to add to the
installation.
6 Repeat steps 4 and 5 for each additional computer you are adding to the installation.
7 Connect the included power supply to the KVM switch, and then plug it into an appropriate power source. To help protect
your system from sudden transient increases and decreases in electrical power, it is recommended that you plug your
devices into a Tripp Lite surge suppressor, line conditioner or uninterruptible power supply (UPS).
8
Turn on the power to all connected devices.
3
4 5 6
1
6
2 3