Foss 5027 Manual Del Usuario página 16

5027 Sampler
Mode Configuration
0 Scaba 5600
3 MilkoScan FT 120
4 FIAstar 5010 and Aquatec 5400
5 FIAstar 5010 and Aquatec 5400
9 WineScan and FIAstar 5000
C FIAstar 5012, Scaba 5610 and 5611
D FIAstar 5000, FIAstar 5012 and Wine-
scan
F Test and adjustment
Note:
If you change the position of the switch, the sampler must be reset.
" "
Fig. 5:2 The MODE switch
5.4 Starting the Sampler
Connect the mains cable to the wall socket and start the sampler by pressing the
mains switch on the rear. The green LED at the front lights up when the power is on.
The sample probe will automatically move to the wash bottle if it accidentally moved
out of this position.
5.5 Operation
Use the table in section 5.3 Setting the Analysis Configuration, to set up the mode
switch in the desired position. Remember to restart the sampler for a change to take
effect. Usually the PC software of the different analysis systems include a functional
or diagnostic test of the sampler, if you wish to check it further.
5:2
Trays Logic
32 TTL
56 RS232
32 TTL
120 TTL
64 RS232
32 RS232
120 RS232
TTL
5027028a
User Manual 5000 3694 / Rev. 3