SUOMY MX SPEED PRO Manual Del Usuario página 26

PADDING — G — H — Figure 7
The inner padding, can be easily removed to be washed or replaced.
FIGURE 7
Inner central padding: INNER SHELL — G — I — Figure 8
Removing and Assembly
The inner shell (G) is fixed to the helmet through 4 press studs (I).
Removing
Snap to open the press studs (I) and remove the inner shell (G).
Be very careful when removing the shell, press on the rigid part of
the stud and pull slightly towards the inside of the helmet without
damaging the press stud.
Caution: to avoid damages to the inner lining, before removing the
inner shell make sure that all the press studs have been unhooked.
Assembly
Insert the shell (G) inside the helmet checking the assembly
direction. Fasten the press studs (I). After fixing the inner shell,
make sure that the shell is correctly positioned inside the helmet
(polystyrene padding).
26
G
H
H
G
FIGURE 8
Inner side padding: CHEEK PADS — H — Figure 9/10
Removing and Assembly
Removing — Figure 9
Cheek pad is fixed to the shell through three press studs, to
remove unfasten the three studs by slightly pulling outwards. After
unfastening the buttons, slide out the pad by releasing the strap from
the slot in the pad.
FIGURE 9
I
I
I
I
H