SUOMY MX SPEED PRO Manual Del Usuario página 22

MAINTENANCE
To clean the shell use water and mild soap; let the helmet dry at room
temperature, never expose it to heat.
Cleaning the helmet with solvents, petrol by-products or chemical
substances, the application of stickers or paint could affect the
structure of the shell, thus affecting the safety features, even if the
damage is not readily visible.
Do not paint, or apply stickers, petrol or other chemical solvents to
this helmet.
To clean the internal lining, just hand wash at 30°C maximum,
exclusively using mild soap.
To clean the fixed internal lining use a damp cloth and mild soap.
The fabric lining, even if they are part of removable elements, must
not be soaked in water when they are applied to or paired with an
internal padding, either rigid or soft.
Dry the pieces at room temperature, away from sunlight and without
exposing them to heat sources.
Periodically clean the «D-Rings» system with warm water and
mild soap. Do not use solvents or chemical detergents and do not
lubricate.
Some colorings are made with Fluo UV paints that could be subject
to the natural migration phenomenon with a drop in intensity. The
phenomenon could be enhanced when the helmet is exposed for long
periods to a particularly intense light. However, this does not affect the
performances and the quality of MX SPEED PRO
Suomy therefore, cannot be held responsible if this should occur.
22
USER'S INSTRUCTIONS
RETENTION SYSTEM D-RING — Figure 2
Insert the free end of the strap into the rings (I-II). Pull until the strap
fits tightly around the jaw. After doing this, it should be impossible to
slide out the helmet; verify that, by taking it from the back edge and
rotating it towards the front, the helmet cannot be removed and that
it remains well fixed on your head. If the helmet tends to come off or
it moves freely on the head, pull the strap tight until the right pressure
is reached and repeat test. If after repeating the test you are not able
to efficiently tighten the retention system, do not use the helmet.
Only after the strap has been adjusted tightly, fix the end part of the
strap by fastening it with the press stud (III) on the tongue. (Figure 2).
I
FIGURE 2
II
III