Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Chapter 3
Power Supply and Fan Module Installation
Warning
Warning
Warning
Installing an AC-Power Supply Module
Warning
Step 1
Step 2
Step 3
Step 4
78-17647-02
The plug-socket combination must be accessible at all times, because it serves
as the main disconnecting device. Statement 1019
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Do not work on the system or connect or disconnect cables during periods of
lightening activity. Statement 1001
This section describes how to remove and install a 750-W or a 1150-W AC-power
supply module in the RPS 2300.
(Optional) A single ground screw and lug ring ships with the RPS 2300. Use the
ground screw to attach to single ground lug to the RPS rear panel (see
on page
1-16). Using a ratcheting torque screwdriver, torque the ground-lug
screw to 60 lbf-in. (960 ozf-in.).
The plug-socket combination must be accessible at all times, because it serves
as the main disconnecting device. Statement 1019
To remove and install an AC-power supply module, follow these steps:
Disconnect the power cord from the power source.
Detach the power cord retainer from the power cord.
Remove the power cord from the power connector.
Use a Phillips screwdriver to loosen the two captive screws at the lower edge of
the power supply module that secure the module to the RPS 2300 chassis.
Cisco Redundant Power System 2300 Hardware Installation Guide
Installing an AC-Power Supply Module
Figure 1-9
3-3
Capítulos
Tabla de contenido
