Cisco Systems Power System 2300 Guía De Instalación De Hardware página 24

Front Panel Description
Table 1-1 Status LEDs
LED Off
Standby/Active Not powered
on.
Temp Not powered
on.
Fan Not powered
on.
Table 1-2 DC Output LEDs
Color
Off
Green
Blinking green
Blinking amber
Cisco Redundant Power System 2300 Hardware Installation Guide
1-10
Green
The RPS 2300 is in
active mode and can
back up a failed
device.
The RPS 2300
internal temperature
is less than 113°F
(45°C).
The fan module is
operating properly.
The six DC output LEDs display the status of the six RPS output connectors that
you use to connect the RPS 2300 to the switch. The output LEDs are numbered 1
to 6, which corresponds to the numbers on the DC outputs.
colors and their meanings.
DC Output Status
The RPS 2300 is not powered up, or no device is connected to the DC output
connector.
The RPS 2300 is connected to a device through this port and is ready to back
up a device.
The RPS 2300 is backing up the connected device.
The RPS 2300 is in standby mode.
Chapter 1
Blinking Amber Amber
The RPS 2300 is in The power supply
select mode. The modules are not
selected port is in compatible with each
standby mode and other, or the RPS 2300
is not ready to back is in an overtemperature
up a device. or overcurrent
condition.
The RPS 2300 The RPS 2300 is in an
internal overtemperature
temperature is in condition. Greater than
the elevated range. 31°F (55°C).
113 to 131°F
(45 to 55°C)
— The fan module is not
operating properly.
Product Overview
Table 1-2 lists the LED
78-17647-02