Fan Module; Leds - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Front Panel Description
Figure 1-6 RPS 2300 Front Panel
100 -240
V
10-5 A
AC OK
50-6 0 HZ
DC OK
ST DB Y
AC TIV E
TE MP
FA N
1
Power supply module
1

Fan module

2
Power supply module
3
Fan Module

LEDs

Cisco Redundant Power System 2300 Hardware Installation Guide
1-8
Re du nd an
DC OU TP
/
t Po we r
1 UT
Sy ste m 23
2
00
3
4
5
6
SE LE CT
ST DB Y/
AC TI VE
2
The RPS 2300 fan module includes the system status LEDs, the DC output power
LEDs, and the Select and the Standby/Active buttons for the RPS 2300 (see
Figure 1-7 on page 1-9).
The RPS 2300 supports hot swapping of the fan module. You can remove and
replace the module without disconnecting the system power and without
interrupting normal system operation. For information about installing and
removing the fan module, see
section on page 3-1.
The LEDs on the front of the fan module (see
status and if it is powering a connected device. The fan module has three bicolor
LEDs for system status and six bicolor LEDs for DC port status, as described in
Table 1-1 and Table 1-2 on page
100 -240
V
10-5 A
AC OK
50-6 0 HZ
DC OK
3
"Power Supply and Fan Module Installation"
1-10.
Chapter 1 Product Overview
Figure 1-7) shows the RPS 2300
78-17647-02