Product Description - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Product Description

Figure 1-1 Cisco RPS 2300
100 -240
V
10-5 A
AC OK
50-6 0 HZ
DC OK
ST DB Y
AC TIV E
TE MP
FA N
Cisco Redundant Power System 2300 Hardware Installation Guide
1-2
supply modules. The number of switches that the RPS 2300 can back up depends
on the number and capacity of the power supply modules in the RPS 2300.
Table 1-3 on page 1-14
The six DC ports on the RPS 2300 provide the power and serial management bus
(SMB) communication signals to the Catalyst 3750-E and 3560-E switches. The
RPS 2300 communicates with each switch through the SMB embedded in the
22-pin RPS cable. This allows all connected 3750-E and 3560-E switches to
simultaneously communicate with the RPS 2300.
When connected to the Catalyst 3750-E and 3560-E switches, you can configure
these RPS 2300 features through the switch software:
Enable RPS active or standby mode for each connected device
•
Configure the switch priority for RPS support
•
List the connected switches and their power-supply module size
•
Report when a switch is powered by the RPS
•
Report the RPS power-supply module status
•
Read and monitor backup, failure, and exception history
•
The RPS 2300 supports the Catalyst 3750-E and 3560-E switches and other Cisco
devices. For a complete list of supported products, see the online Redundant
Power System 2300 Compatibility Matrix posted with the RPS 2300.
Re du nd an
/ DC OU TP
t Po we r
1 UT
Sy ste m 23
2
3 00
4
5
6
SE LE CT
ST DB Y/
AC TI VE
shows the supported power supply configurations.
100 -240
V
10-5 A
AC OK
50-6 0 HZ
DC OK
Chapter 1 Product Overview
78-17647-02