Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTRUCCIONES DE
FUNCIONAMIENTO
NOTA: Antes de usar la herramienta,
lea el manual de instrucciones
atentamente.
INTENDED USE:
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight and curved
cuts with mitre angles to 45°. The saw blade
recommendations are to be observed.
ASSEMBLY
1. FIT / REMOVE THE BLADE (SEE FIG.A)
NOTE: When changing blades, set the pendulum
action switch to "3".
A
The pendulum jig saw is equipped with a tool free
blade holder (16). To open the blade holder, rotate
the ring clockwise and hold in position. Fully insert
the blade (9) into the holder slot with blade teeth
facing forward and release the ring, which will
self-rotate and clamp over the top of the blade.
Push the blade into the holder again to ensure it is
locked in position. Ensure the edge of the blade is
located in the groove of the roller guide (10).
To remove the blade, hold the blade and rotate
the ring clockwise then pull out the blade.
Note: For best cutting results, ensure that you use
a blade suited to the material and cut quality you
need.
WARNING:
Blade teeth are very sharp.
●
Blade self-eject out swiftly.
●
Do not point at people.
●
2. ASSEMBLE THE DUST COVER (SEE FIG B)
To remove the dust cover (5), firstly remove
the edge of the dust cover slightly. Then slide
onwards from one side of the steel wire. Pull out
the dust cover.
To replace it, fit the dust cover from the frontage of
the steel wire. Press inward and then slide until it
reaches the groove.
B
WARNING:
Do not operate the tool without the dust
cover or with the damaged cover.
3. ADJUST THE PARALLEL GUIDE (SEE
FIG.C&D)
The parallel guide helps you to make an accurate
parallel cut. Release the locking screws (7). Insert
the parallel guide (8) from the appropriate side
(left or right) accordingly and slide to the required
position then lock the screws. Make sure that
the guide surface of the parallel guide points
downwards.
C
D
4. ASSEMBLE THE VACUUM ADAPTER (SEE
FIG.E)
35
Tabla de contenido
