Care And Servicing Of Your Andis Trimmer Blades - Andis SLII Instrucciones De Uso Y Cuidado

A
D
ARMATURE
PIN

CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES

Blades should be oiled before, during, and after each use. If your trimmer
blades leave streaks or slows down, it's a sure sign blades need oil. The
trimmer should be held in the position shown in Figure A to prevent oil from
getting into motor. Place a few drops of Andis Clipper Oil on the front and
side of the cutter blades (Figure B). Wipe excess oil off blades with a soft
dry cloth. Spray lubricants contain insufficient oil for good lubrication, but
are an excellent blade coolant. Always replace broken or nicked blades to
prevent injury. You can clean the excess hair from your blades by using a
small brush or worn out tooth brush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus while
the trimmer is running. Any excess hair and dirt that has accumulated
between the blades should come out. After cleaning, turn your trimmer off
and dry blades with a soft, dry cloth and start clipping again.
REPLACEMENT (REMOVAL) OF BLADE SET
Your Andis SLII trimmer has a preset tension assembly on the blade set.
To remove blade set from your trimmer, unplug trimmer from electrical
outlet. Turn the trimmer upside down so teeth of blades are facing down.
You may wish to set the trimmer on a flat surface while performing these
operations. Using a phillips type screwdriver, unscrew the two blade
4
B
OIL
BLADE
YOKE
C
BLADE SCREWS
E
POWER
SCREW