Residual Risks; Environmental Protection - Ryobi RLSW01 Traducción De Las Instrucciones Originales

Use personal protective equipment.
– Use safety glasses.
– Use a face or dust mask if working operations
create dust.
– Wear ear protectors. Exposure to noise can cause
hearing loss.
– Wear protective footwear. Objects, including parts
of the workpiece may fall from the stand.
Make sure any power cord is located so that it will
not be stepped on, tripped over, come in contact with
sharp edges or moving parts or otherwise subjected to
damage or stress. This will reduce the risk of accidental
falls, which could cause injury, and damage to the cord,
which could result in electric shock.
Check for damaged parts. Before further use of the
product, it should be carefully checked to determine
that it will operate properly and perform its intended
function.
When not in use, the product should be stored in a
dry locked-up place, out of the reach of children and
persons unfamiliar with it.
When moving the stand or saw and bracket assembly,
keep balanced to avoid injury.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
Over balancing. When a large piece is cut from one
end of a job, the remaining piece may be heavy enough
to tip the stand. Always ensure the workpiece is well
supported.
Risk of a collapse of the product. Check to make sure
that all fixing screws and knobs are tight and all parts
are locked into place before operating the stand.
Unclamped workpieces can cause severe injury and
damage. Secure the workpiece in the vise or clamp to
the stand to prevent it from moving whilst you work on it.
KNOW YOUR PRODUCT
See page 81.
1. Top rail
2. Saw mounting bracket
3. Work stop adjustment knob
4. Extension arm
5. Work support adjustment knob
6. Handle
7. Release lever
8. Wheel
9. Work stop
10. Work support
11. Support arm locking lever
12. Mounting bracket locking lever
13. Central brace
14. Frame support
15. Foot
2 | English
MAINTENANCE
Do not modify the product in any way or use accessories
not approved by the manufacturer. Your safety and that
of others may be compromised.
Before and after each use, check the product for
damage or broken parts. Keep the product in top
working condition by immediately replacing parts with
spares approved by the manufacturer.
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Do not at any time let brake fluids, gasoline, petroleum-
based products or penetrating oils come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised service centre.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
Please read the instructions carefully
before starting the machine.
Wear ear protection
Always wear eye protection.
136
Do not exceed 136 kg.
Do not stand on top or use as ladder.
Do not sit on top.
Do not reach into the gap. Beware of
pinching.