Residual Risks; Assembly; Setting Up; Mount The Sharpener - Parkside PSS 65 A1 Traducción Del Manual De Instrucciones Original

G B M T
Therefore, proceed cautiously and hold
slipping which could cause your hands
to come into contact with the grinding
belt or grinding wheel.
• The workpiece gets hot during grinding.
Do not touch the machined area, allow
it to cool down. There is a risk of burn-
ing. Do not use coolants or the like.
• If you are tired or have consumed al-
cohol or tablets, do not work with the
device. Always have a break on time.
• Switch the device off and remove the
mains plug
- to loosen a blocked insertion tool,
- if the connection line is damaged or
entangled,
- in case of unusual sounds.

Residual risks

Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this elec-
tric tool may present the following hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear pro-
tection is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding wheels.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electromag-
stances, may impair the functionality of
4 0
active or passive medical implants. To
reduce the risk of serious or lethal inju-
ries, we recommend that persons with
medical implants consult their doctor
and the manufacturer of their medical
implant before operating the machine.

Assembly

Caution! Risk of injury!
space in which to work, and that
you do not endanger other people.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the device.

Setting up

face and fasten the device. Ideally, bolt the
drill to the surface. Use the mounting holes
for the work bench assembly (
baseplate for this.
sembly are not part of the scope of
delivery.

Mount the sharpener

1. Select one of the three sharpeners.
2. In order to remove a sharpener
from the working position, you
must press down the release lever
for the sharpener (
3. Remove the sharpener from the
guide rails, upwards.
4. In the storage positions, the sharp-
- and left side and can be easily
removed from the guide rails.
-
9) in the
-
13).