Sharpening Picks And Chisels; Sharpening Knives - Parkside PSS 65 A1 Traducción Del Manual De Instrucciones Original

G B M T
6. Using the knurled nut fasten the
drill for drill-fastening (12).
7. Remove the drill holder (14) and
insert this into the rotatable drill
mount (11) from below using the
knurled nut for drill-fastening (12).
8. Check the alignment of the drill. The
cutting edges of the drill must be
touching the grinding wheel (10).
9. Switch the device on and grind
the drill by moving the rotatable
drill mount (11) to and fro in the
direction of the arrow.
10. Switch the device off and wait for
the grinding wheel (10) to stop.
11. Remove the drill holder (14)
and insert it into the rotatable
drill mount (11) by rotating in
by 180°. Using the same adjust-
ment, you can grind the opposite
cutting edge of the drill.
12. Switch the device off and grind
the drill.
13. Switch the device off and wait for
the grinding wheel (10) to stop.

Sharpening picks and chisels

1. Mount the selected sharpener
(see Mounting sharpener).
2. Place the blade on the tool ta-
ble (6) so that it lies against the
spacer (4). The magnetic holder
(5) keeps the blade in position.
3. Release the retaining screw for
the angular adjustment (7) and
turn the tool table (6) into posi-
tion. Select the angle according
to the existing bevel angle (angle
of the bevelled edge).
4. Tighten the retaining screw for
angular adjustment (7) again.
4 2
5. Switch the device on and move the
along the grinding wheel (10).
6. Always use light pressure while
sharpening and slowly push the
blade towards the grinding wheel
(10).
7. Repeat the sharpening process
until all irregularities have been
removed.
8. Switch the device off and wait for
the grinding wheel (10) to stop.
To sharpen a chisel, turn the chisel
over and repeat the process from
Point 5.

Sharpening knives

The device is not suitable for grind-
ing serrated knives.
1. Mount the selected sharpener
(see Mounting sharpener).
2. Turn the machine on.
3. Insert the blade of the knife right
into the grinding slot.
4. Using light pressing guide the
blade along the grinding wheel
(10) and evenly and slowly pull
the knife towards you.
5. Turn the knife and insert the knife
blade into the opposite grinding
slot.
6. Repeat this grinding process for
this side of the blade as well.
7. Execute the alternating grinding
process until the cutting edge is
burr-free and sharp.
8. Switch the device off and wait for
the grinding wheel (10) to stop.