Canopy Assembly - Craftmade Inspo INS54 Guia De Instalacion

6. Wiring. (cont.)
IN ORDER TO WIRE WALL CONTROL,
remove existing wall switch. Wire the wall
control with wire connectors provided as
shown in diagram at right.
WARNING: CONNECT WIRES IN THE
FOLLOWING ORDER ONLY!
Connect GREEN wire with YELLOW STRIPE
(ground) from wall control to ground from
house or directly to one of the screws from
the outlet box.
Connect BLACK wire from wall control to
BLACK (hot) lead wire from house.
Connect BLACK wire from wall control to
BLACK load wire to fan.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire
connectors into outlet box.
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
front plate to wall control using 2 screws
provided in the wall control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green with yellow
green/ green/ green/
stripe (GROUND)
bare bare bare
ground ground ground
black
(TO POWER SUPPLY)
black
(AC IN from
breaker box)
(wiring for wall control)
canopy
screw
page 7
radio
wall control
BLACK
hanging
bracket
screw
canopy cover
radio
or television
plate