Troubleshooting Chart - Speedaire 1ZMG5 Manual Del Usuario

Speedaire ® Operating Instructions and Parts Manual
Speedaire ® Paint Tank
Maintenance
Always
which contain trichloroethane,
shut off
chlorinated hydrocarbons,
air pressure at source and
nitrohydrocarbons, esters, amines, or
bleed off all pressure in paint
organic compounds. These materials will
tank by gently pulling safety
damage the gasket between the paint
valve ring before loosening knobs to
tank and lid. A damaged gasket may
remove lid.
E
cause injury and will reduce the efficiency
of the paint tank.
N CLEANING
G IMPORTANT: It is very important that
6. Pour about 1/2 gallon of paint solvent
L the tank material hose and spray gun be
into the tank. Use the correct type of
I
cleaned as soon as the spray job is solvent for the paint being used:
S completed.
mineral spirits for oil base paint,
H
lacquer thinner for lacquer base
1. Shut off air tank at air pressure
paints, warm soap water for Latex,
regulator by turning adjusting screw
etc.
counterclockwise.
7. Clamp lid onto tank and proceed to
2. Gently pull safety valve ring to purge
spray the proper solvent through air from tank.
spray gun and hose.
3. Completely cover spray gun nozzle
8. Following steps 1 through 9 in this
with a soft rag and with air lines
section, remove all thinner from hose.
pressurized, pull trigger of the gun.
This will force paint remaining in the
9. Clean lip of tank groove of paint tank
material hose back into the tank. lid and gasket.
4. Remove tank lid and pour any
remaining paint back into original
containers for future use.
5. Using a clean, dry cloth, wipe inside
area of tank clean.

Troubleshooting Chart

Symptom Possible Cause(s)
No material coming 1. Plugged hoses or material tube
from tank
2. Damaged regulator diaphragm
3. Incorrect hose connections
Air leak at tank lid 1. Damaged gasket
2. Dirty tank rim
3. Eyebolt knobs not tightened securely
1ZMG5
Never use this paint CLEANING THE SAFETY VALVE
tank with materials
Remove the safety valve and clean port
(orifice) periodically. Accumulations of
paint in the port can prevent proper
valve action. Do not disassemble valve or
change settings.
This component has
been factory
calibrated and sealed. Do not attempt to
disassemble safety valve or alter
calibration.
ROUTINE
Periodically inspect the tank for leaks
around the paint tank lid. If leakage
occurs, remove the pint tank lid and
clean lip of tank and groove in tank lid.
Replace gasket.
Corrective Action
1. Check hoses and material tube
2. Check regulator for leaks. Replace diaphragm if
necessary
3. Check connections according to instructions
1. Replace gasket
2. Clean rim
3. Check tightness (See Operation)
Purge all air from tank before
adjusting eyebolt clamps
4
Speedaire ® Instructions d'Utilisation et Manual de Pièces
Modèle 1ZMG5
Notes
5 Fr
F
R
A
N
Ç
A
I
S
®