Button Functions; Indicator Leds - Urmet Miro Manual Del Usuario

BUTTON FUNCTIONS

State
STAND-BY
Button
Open
pedestrian
door
---
Special
function
(default: 7)
Garage door
opener
(*) To enter and exit programming state, hold button pressed for longer than 5 seconds. The yellow LED
will blink slowly to indicate that programming mode is selected. Programming mode will shut down in all
cases after the 10 minute timeout.

INDICATOR LEDS

6. Multicolour indicator LED
PRIORITY FUNCTIONS
1 Fast fl ashing red: muted ring tones
2 Green blinking: automatic door opener on
3 Red on steady: main calling station door open
4 Slowly blinking red: secondary calling station door open
5 Slowly blinking yellow: programming state on
To save the programming, remember to exit from the same by pressing the
then 5 seconds; in any case, after 10 minutes the device exists the programming state and saves
the parameters changed. Refer to the system booklet for how to program intercom calls.
9. Green LED under the
On steady:
On blinking:
11. Green LED under the
On steady:
RESET
To restore default parameters of the device after entering programming mode, hold button
longer than 5 seconds, press the
emit 2 long beeps to confi rm and exit the programming state.
10
WAITING
FOR PICK-UP
DURING AUDIO OPERATION
(RECEIVING
CALL)
Open
pedestrian Open pedestrian door
door
If pressed in the operating mode:
A) "Hands Free" ends the
conversation;
B) in "Push to talk":
Audio
— if pressed a long time, it
activation
enables the audio of the door
unit;
— if short pressed it activates or
terminates the conversation.
Special
function Special function (default: 7)
(default: 7)
Garage door
opener
button
call in progress
conversation ongoing
button
possibility of a door opening
and
Garage door opener
buttons together for longer than 3 seconds. The system will
STAND-BY
PROGRAMMING*
AND BUTTON
(ONLY WITH
DOOR PHONE IN
PRESSED
STAND-BY)
Open Connect / disconnect the
pedestrian automatic door opening
door
Call volume adjustment
for door and fl oor level
--- calls (the possible volume
adjustments are, in this
order, HIGH, LOW, MUTE)
Programmable
Floor call ring tone
intercom call
selection (5 different ring
2 (Default: not
programmed)
Programmable
intercom call 1 Door phone call ring tone
(Default: call to (5 different ring tones)
switchboard)
button for more
STATE OF
system
tones)
pressed for
DS1183-013A