Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll Rand 5102MAX Especificaciones Del Producto

Product Safety Information

Intended Use:
These die grinders are designed for grinding, porting, polishing, de-burring, and breaking sharp edges.
For additional information refer to Air Die Grinder Product Safety Information Manual
Form 04580288.
Manuals can be downloaded from ingersollrand.com

Product Specifications

Free Speed
Model(s)
rpm
5102MAX 20000
5108MAX 25000
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. MAX Series Die Grinder vanes are made of a special material that does not require
constant lubrication. However, we do suggest periodic lubrication for optimum service life. See
drawing 16573164 and table on page 2. Maintenance frequency is shown in a circular arrow and
defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.
48483697_ed5
Sound Level dB(A)
Collet Size
mm † Pressure (L
1/4" (6 mm) 84.1
1/4" (6 mm) 83.3
WARNING
6.
7.
8.
9.
10. Grease
(ISO15744)
) ‡ Power (L )
p w
95.1
94.3
Thread size
Coupling
Safety Air Fuse
Oil
EN
Vibration (m/s²)
(ISO28927)
Level *K
3.3 1.1
1.8 0.8
EN-1