Dry Ironing - Black+Decker POWER PRO AS600 Manual De Instrucciones

F
lowest heat setting, move the dry/steam selector to
Vertical Steam
Use for removing wrinkles from hanging clothes and drapes.
1. Make sure the water tank is filled to the MAX mark and iron is plugged into
electrical outlet.
G
H

DRY IRONING

1. Make sure the dry/steam selector is set to
water(see "Emptying Water Tank After Ironing - Optional").
2. Turn the fabric-select dial to the appropriate setting for your fabric. See
fabric guide on the heel rest and read garment's label to help you determine
fabric type.
EMPTYING WATER TANK AFTER IRONING (OPTIONAL)
Note: It is not necessary to empty the water after each use.
1. Turn the fabric-select dial to
J
3. Press the surge-of-steam button
of steam (F). For best performance, leave an interval
of 5 seconds between bursts.
Important: Always stand the iron on its heel rest when
powered on but not in use.
4. When finished ironing, turn the fabric-select dial to
2. Hang the garment to be steamed on a clothes hanger.
(Curtains or drapes can be steamed once they are
hung.)
3. Set the dry/steam selector to desired steam level
4. Hold the iron close to, but not touching, the fabric.
5. Pull the fabric tight in your free hand and pump the
surge-of-steam button as you move the iron over the
fabric (G).
SPRAY
You can use spray at any setting (H).
1. Open the water-fill cover.
2. Fill water tank up the MAX mark.
3. Press the
4. If spray is weak, pump the button a few times.
. Unplug the iron and let it cool.
2. Open the water-fill cover to expose water hole.
3. Empty the water by holding the iron over a sink with
the tip pointing down. Water will empty out of water-fill
opening (J).
button to spray water as you iron.
. You may want to empty the
to generate a burst
and unplug the iron.
.
15