Installing The Seat; Assembling The Steering Wheel - Murray LT155420 Manual De Instrucciones

Installing the Seat

How to Install the Seat
1. Carefully remove the plastic bag from the seat.
Use the fasteners shown below to install the
seat. The fasteners are shown at full size.
Figure 4: Seat parts
A - Wing bolt (Also see 'E' in Figure 3)
B - Washer (Also see 'F' in Figure 3)
NOTE: Fasteners may be attached to seat for
shipping purposes, if so remove fasteners before
proceeding.
2. Align the holes in the seat hinge to the holes in
the seat (Figure 5). Fasten the seat to the seat
hinge with the fasteners as shown.
3. Check the operating position of the seat. If the
seat needs to be adjusted, loosen the two wing
bolts. Slide the seat forward or backward along
the seat adjusting holes as shown. Tighten the
wing bolts (A).
Figure 5: Seat
A - Wing bolt
B - Washer
C - Seat adjusting hole
D - Seat hinge
E - Seat
English
A B
E
D
C
B
A

Assembling the Steering Wheel

How to Assemble the Steering Wheel
Tools Required: 3/8" Socket Wrench
Attach the steering wheel as follows:
A
Figure 6: Steering wheel parts
A - Screw (Also see 'C' in Figure 3)
B - Washer (Also see 'D' in Figure 3)
1. Make sure the front wheels point forward.
2. Slide the bellows over the steering post
(Figure 7).
NOTE: Before attachment of the steering wheel,
make sure that the front wheels point forward and
are straight. For proper alignment of the steering
wheel, see Figure 7.
3. Slide the steering wheel onto the steering post.
4. Use the fasteners shown above to secure the
steering wheel. The fasteners are shown at full
size. Tighten the screw until snug and then add
1/4 turn. DO NOT over tighten.
5. Attach the cover to the steering wheel.
6. Some models have an optional decal in the parts
bag. Attach the decal to the center of the
steering wheel as shown.
B
7