Storage - Murray LT155420 Manual De Instrucciones

3. Install a new light bulb. Align the light socket
with the notches in the bezel and turn the light
socket to lock in position.
C
Figure 46: Light bulb replacement
A - Bezel
B - Light bulb
C - Light socket
How to Clean the Mower Housing
WARNING: Before you clean the mower
housing, stop the engine and disconnect
the wire to the spark plug.
Grass and other debris on top of the mower housing
can keep the belt from working correctly. For safety
and correct operation, frequently clean the top of the
mower housing. Remove grass and debris from
around the pulleys and other moving parts.
1. Move the lever for the blade rotation control to
the ENGAGE position.
2. Clean the top of the mower housing.
3. Move the lever for the blade rotation control to
the DISENGAGE position.
4. Again clean the top of the mower housing.
5. After you cut the grass, clean the bottom of the
mower housing.
Storage (over 30 days)
At the end of each year, prepare the unit for storage
as follows.
The Engine
For storage information, see the the engine
manufacturer's instructions.
English
The Battery
1. Remove the battery.
2. Clean the battery terminals of any deposits.
3. Charge the battery. See the instructions on "How
4. Store the battery in a cool, dry place.
NOTE: After a long time in storage, charge the
battery.
The Fuel System
A
B
1. Start the engine.
2. Run the engine until the fuel tank and the
3. After storage, make sure you use fresh fuel.
Clean the Unit
1. Clean the dirt and grass from the engine.
2. Clean the mower housing.
Lubricate the Unit
See the "Lubrication" instructions in this book.
To Prepare And Charge The Battery".
WARNING: Do not drain the gasoline inside
a building or near a fire. Do not smoke
because the fumes from the fuel can cause
an explosion.
carburetor are out of fuel and the engine stops.
35