Grammer MSG83 Manual De Instrucciones página 19

•
To prevent injury,
seat.
•
removed from the seat cushion and the backrest upholstery.
•
To eliminate any risk of accident, the settings must be checked to ensure they are
correctly engaged
•
Adjustments must
•
example held in place, before the backrest adjuster is operated. If you fail to do so, there
is a danger that the backrest frame may jerk forward and
•
are not original
tested.
•
During the removal and installation of the driver's seat, the corresponding instructions by
the specific vehicle manufacturer must be strictly observed!
•
Do not hold onto the covers for lifting the driver's seats. If you do so anyway, there is an
•
Before you remove the driver's seat, disconnect all plug-in connections between the seat
and the vehicle supply network. When you replace the plug-in connectors, make sure they
are tight (dust, water).
•
Seatbelts can be retrofitted to the driver's seat. Seatbelts
area.
Seatbelts must be fitted in accordance with specific national regulations and guidelines,
and must be approved by
•
Retrofitted seatbelts must be fastened
Where seatbelts are fitted to the driver's seat, the
checked
•
Fasteners must be
may be loose bolts or other faults.
•
If you notice that the driver's seat does not function correctly (for example a defective seat
suspension; improper curvature of the lumbar support or damaged bellows),
If you fail to do so, your health may be affected and the
GB
of the driver's seat, possible
be made
of the driver's seat (for example fitting parts which
parts) may impair the safety standard to which it has been
, threatening your
of the driver's seat must be approved by
.
after an accident.
by specialist personnel after an accident has occurred.
to arrange for repairs to be carried out.
.
.
, the backrest frame must be supported, for
, as they increase the load in the seat mounting
.
and
. If the driver's seat wobbles there
Safety instructions
of the driver's
has to be
.
. For this reason,
.
.
must be
.
19