General Instructions; Safety Instructions - Grammer MSG83 Manual De Instrucciones

General instructions

•
The operating instructions must be read in full before use.
•
The operating instructions must be kept in the vehicle and always be at hand.
•
The driver's seat may only be fitted, serviced and repaired by specialist personnel,
in accordance with national regulations and the vehicle manufacturer's fitting instructions.
The national fitting regulations can be obtained from
company, or from the vehicle manufacturer.
•
A correctly functioning and individually adjusted driver's seat is essential to your health.
Take adequate care of your seat and have it serviced regularly to ensure that it functions
correctly.
The functional checks are to be carried out at least as regularly as vehicle services
(see maintenance plan for vehicle).
•
These operating instructions should always be kept with the driver's seat. If the driver's
seat is passed on to a third party, it must be accompanied by the relevant operating
instructions.

Safety instructions

•
If you need to connect cables to the vehicle supply network, strictly observe the following
instructions:
Before you connect a seat switch or a seat heater, you must obtain the relevant electrical
data for the respective vehicle with reference to voltage, protection and the kind of
connections from the manufacturer, from
For safety reasons, the installation and connection to the vehicle supply network must be
carried out by authorized specialist personnel only.
The seat connections must be protected independently of other vehicle components.
Seat heater
12V DC
24V DC
purely resistive load.
In case of inductive or capacitive load, the manufacturer must install a protective circuit
breaker for the consumers in the vehicle. If there are any uncertainties,
•
Driver's seats that have been adjusted incorrectly have a smaller moving area. To prevent
damage to the driver's back and to the driver's seat, the seat must be adjusted for the
driver's weight
18
10A
10A
Minimum and maximum current carrying capacity for
and
or the company's agencies.
Seat switch – current carrying capacity
12V DC
250V DC
.
or from agencies of the
10mA (min.)
5A (max.)
.
GB