Setup 6: Adjust The Tilt; Setup 7: Insert Batteries Into The Remote Control - Sony MFM-HT75W Manual Del Usuario

If no picture appears on the screen
• Check that the power cord and the video signal cable are
properly connected.
• If "No Input Signal" appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing the
button (page 12).
• If "Cable Disconnected" appears on the screen:
– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by pressing the
button (page 12).
• If "Out of Range" appears on the screen, reconnect the old
display. Then adjust the computer's graphics board within the
following ranges.
MFM-HT75W
Analog RGB
Horizontal
28–69 kHz
frequency
Vertical
48–85 Hz
frequency
1280 × 768 or less
Resolution
MFM-HT95
Analog RGB
Horizontal
28–86 kHz
frequency
Vertical
1)
48–85 Hz
frequency
1280 × 1024 or less
Resolution
If the resolution is 1280 × 1024, the vertical frequency should be in the
1)
range of 48–75 Hz.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 38.
No need for specific drivers
The display complies with the "DDC" Plug & Play standard and
automatically detects all the display's information. No specific driver
needs to be installed on the computer.
The first time you turn on your computer after connecting the display, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play display is automatically selected so that you
can use this display.
The vertical frequency is set to 60 Hz.
Since flickers are unobtrusive on the display, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Setup 6: Adjust the tilt

This display can be adjusted within the angles shown below.
Grasp the sides of the LCD panel, then adjust the
screen angles.
Digital RGB
28–48 kHz
To use the display comfortably
Adjust the viewing angle of your display according to the height
60 Hz
of your desk and chair so that light is not reflected from the screen
1280 × 768 or less
to your eyes.
Notes
• When adjusting the screen tilt, proceed slowly and carefully, being sure
Digital RGB
• When adjusting the screen tilt, make sure not to knock or drop the
28–64 kHz
60 Hz
Setup 7: Insert batteries into the
1280 × 1024 or less
Insert two size AAA batteries (supplied) by matching
the + and – marks on the batteries to the diagram inside
the remote control's battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery leakage
• Handle the remote control with care. Avoid dropping it, getting it wet,
not to hit the display against the desk.
display off the desk.
remote control
whenever you anticipate that the remote control will not be used for an
extended period.
or placing it in direct sunlight, near a heater or where the humidity is
high.
approx.
20°
US
13