Installation With Isofix Fasteners + Top Tether. Universal - JANE EXO Instrucciones

1 Installation with ISOFIX fasteners + top tether. UNIVERSAL

1a
Extract the ISOfix fasteners (10) pulling the
lever (12) situated on the front of the base.
1b Guide both fasteners towards the axles and
press until both sides are locked, two green
lights on the front panel (11b) or two green sig-
nals on the fasteners (10) will indicate that both
are fastened. If one or both lights and / or signals
are red, try it again.
1c Pulling the fastener extraction lever again
(12), press the seat against the backrest of the
vehicle. Continue to press while releasing the
lever and the fasteners will remain immobile.
1d Unroll the top tether from its velcro strap
(14c) on the back of the seat.
40
1e
Hook it onto one of the fasteners supplied by
the vehicle manufacturer.
1f Lastly, tighten the strap until the red signal
disappears from the tension indicator (14d).
To remove the seat when using ISOfix:
1g Loosen the Top Tether strap and disconnect
the hook (14a)
1h Release the fasteners sliding both unlocking
buttons (13) inwards. The lights on the front pa-
nel (11c) will light up in red. The signals on the
fasteners will turn red.
1i Remove the seat. You can store the ISOfix
fasteners by pulling the front lever (12) and pres-
sing the fasteners inside the base.