Remove The Chassis Shell; Battery Installation And Connection - Tripp-Lite BP240V65 Manual Del Propietário

5. Installation
Figure 5-2: Exploded Chassis View, Models BP240V65, BP240V65-NIB, BP240V100, BP240V100-NIB

5.4.1 Remove the Chassis Shell

Place the battery cabinet in position. Remove the top, front, left and right panels. Remove the right and left cover plate of the
battery pack and the battery flapper to install the batteries.

5.4.2 Battery Installation and Connection

Each battery group has 20 pieces of batteries in series (BAT+, N and BAT-). Place the batteries in the cabinet from the bottom
to top one-by-one, then connect the battery cables according to the diagrams that follow.
Note: The positive and negative polarity of the battery cannot be reversed or short circuited. Doing so will damage the battery and/or cause
injury. Do not touch the battery's positive and negative terminals at the same time. Before replacing or removing the batteries, disconnect
the breaker, pull up cell terminals and remove the screws of the copper bus bar. Not following the instructions could result in damage to the
equipment or personal injury. The installation must consist of 40 batteries.
18