General Safety Precautions - Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador

1

General safety precautions

WARNING: IMPORTANT SAFETY INSTRUCTIONS
THESE INSTRUCTIONS MUST BE FOLLOWED TO GUARANTEE THE SAFETY
This installation manual is intended for qualified personnel only.
Failure to observe the information included in this manual may result in
personal injury or damage to the equipment.
ROGER TECHNOLOGY cannot be held responsible for any damage or injury due to
improper use or any use other than the intended usage indicated in this manual.
The installation, electrical connections and adjustments must be performed by
qualified personnel, in accordance with best practices and in compliance with
applicable regulations.
Read the instructions carefully before installing the product.
Incorrect installation may pose risks.
Before installing the product, make sure it is in perfect condition: In case of doubts,
do not use the product and refer exclusively to professionally qualified personnel.
Do not install the product in explosive environment and atmosphere: inflammable
gas or vapours constitute serious danger for safety.
Before installing the motor, make all structural modifications related to the safety
precautions and to the protection or segregation of areas involving crushing,
shearing, dragging risks or any other risks.
WARNING: check that the existing structure fulfils the required resistance and
stability specifications.
ROGER TECHNOLOGY is not liable for failure to observe the good practices in the
construction of fixtures to be motorised or for deformations that may occur during
use.
The safety devices (photocells, sensing edges, emergency stops, etc.) must be
installed taking into consideration the following: the regulations and directives in
force, the good practices criteria, the installation environment, the operating logic
of the system and the forces generated by the motorised door or gate.
The safety devices must protect any areas where there is crushing, shearing,
dragging or any other danger in general generated by the motorised door or gate;
the installer is advised to check that the moving wings do not have sharp edges or
anything that may pose shearing and/or dragging risks.
If it is deemed necessary based on the risk analysis, install sensing edges on the
mobile part.
It should be noted that, as provided by the UNI EN 12635 standard, all requirements
of the EN 12604 and EN 12453 standards must be fulfilled and, if necessary, also
checked.
The European standards EN 12453 and EN 12445 define the minimum safety
OF THE PERSONS
PRESERVE THESE INSTRUCTIONS
51