Remove Contents From Carton; Assembly - Powermate PM Serie Manual De Propietario

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
the following:
Accessories
Item
Main Unit
Owner's Manual
Liter Oil SAE 30
Handle Assembly (A)
Never-flat Wheel (B)
Frame Foot (C)
Service Warranty
Emissions Warranty
Battery Charger (electric start models)
Hardware Bag
Rubber Feet (D)
13mm Axle Pin (E)
Cotter Pin (F)
13mm Flat Washer (G)
Hex Flanged M6 Nut (H)
Hex Flanged M8 Nut (J)
M8 Bolt (Short) (K)
M6 Bolt (Short) (L)
M8 Bolt (Long) (M)
3. Call Powermate Customer Service at 1-
800-445-1805 with the unit model and
serial number for any missing carton con-
tents.
Owner's Manual for Portable Generator
Figure 2-9. Instruction Decal
4. Record model, serial number, and date of

Assembly

Qty.
1
Call Powermate Customer Service at 1-800-
445-1805 for any assembly issues or con-
1
cerns. Please have model and serial number
1
available.
The following tools are required to install the
1
accessory kit.
2
• 10mm Wrench
• 13mm Wrench
2
NOTE: The wheels are not intended for over-
1
the-road use.
1
See
Install wheels as follows:
1
1. Slide axle pin (E) through the wheel (B),
Qty.
2
2. Insert cotter pin (F) through axle pin (E).
2
2
Install frame foot and rubber bumpers as fol-
2
lows:
1. Slide hex head bolts (L) through rubber
2
7
2. Slide hex head bolts (K) through holes in
4
2
3. Slide frame foot (C) onto hex head bolts
3
purchase on front cover of this manual.
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Figure 2-10.
wheel bracket on frame, and 13mm flat
washer (G).
Bend tabs (of cotter pins) outward to lock
into place.
bumper (D), then through frame foot (C) (if
not pre-assembled).
frame rail.
(K). Install locking flange nuts (J).
009414
(000100a)
9