Electrical Connection; Operating Instructions - Alto Homecleaner TW 300 S Instrucciones De Manejo

READ THE OPERATING
INSTRUCTIONS AND
OBSERVE THE SAFETY
NOTES!
SAFETY NOTES
Do not pull the machine
along with the mains
lead. Take care not to
crush the mains lead or to
drag it over sharp corners.
Inspect the mains lead at
regular intervals. If the
mains lead is damaged,
the machine must not be
used until the lead has
been replaced with a lead
of the type specified in
the technical data.
If foam or fluid start to
escape from the machine,
switch off immediately.
Use only cleansing agents
approved by Wap/Alto.
INTENDED USE
The machines described in
these operating
instructions are intended
for use in cleaning textile
wall and floor coverings.
The machines are suitable
for commercial use, for
example in hotels,
schools, hospitals,
factories, shops, offices
and rental properties.
FUNCTION
Hot water, mixed with
cleansing agent, is
sprayed under pressure
down to the backing
fabric of the carpet / wall
covering and dissolves the
dirt.
At the same time, a
suction unit draws off the
water and the dirt flushed
to the surface out of the
carpet and into the dirty
water tank.
The pile becomes softer
and uniformly raised.
DESCRIPTION
(FIG. 1)
1 Metering valve
2 Suction / spray hose
3 Lid of dirty water tank
4 Suction / spray tube
5 ON/OFF switch
6 Lid for clean water
tank
ASSEMBLY
Before it is used for the
first time, the machine
has to be assembled:
• Push the suction tube
sections together.
• Push the suction hose
firmly into the spray
extraction cleaner and
the suction tube.
(TW 300 S: Fig. 2a, 4a
TW 350: Fig. 3a, 4a)
• Allow the pressure
hose to engage in the
coupling
(TW 300 S: Fig. 2b
TW 350: Fig. 5a)
• Allow the other end
of the pressure hose
to engage in the
metering valve.
(Fig. 4b)
• To remove the hose,
release the spring-
loaded locking ring.
(Fig. 5a)
ELECTRICAL
CONNECTION
• The mains voltage
must correspond to
the voltage specified
on the rating plate!
(TW 300 S: Fig. 6a
TW 350: Fig. 7a)
• Connect the machine
only to a correctly
installed fused plug
socket with at least a
10 A fuse.
• Turn off the main
switch
(TW 300 S: Fig. 2c
TW 350: Fig. 5b)
• Insert the mains lead
plug into the plug
socket.
7