Hints And Care - Amana XRSS287BB El Manual Del Propietario

Hints and Care

What cleaners does
Amana recommend
for my stainless steel
product?
Amana has a cleaner available for
purchase (Part # 31960801).
For this, or a list of other recommended
cleaning products, please contact your
local distributor.
IMPORTANT: Damage to stainless
steel finish due to improper use of
cleaning products or non-
recommended productions is not
covered under any warranty.
How do I remove
an odor from my
refrigerator?
1. Remove all food and disconnect power
to refrigerator.
2. Clean all interior surfaces including
ceiling, floor, and walls according to
"General" instructions. Pay special
attention to corners, crevices, and
grooves. Include all drawers, shelves,
and gaskets.
3. Connect power to refrigerator and return
food to refrigerator. Wash and dry all
bottles, containers and jars. Wrap foods
in tightly sealed containers to prevent
further odor. After 24 hours, check if
odor was eliminated.
Complete the following steps if odor was not
eliminated.
4. Complete steps 1–2.
5. Place garden fresh crispers on top shelf
of refrigerator section. Pack refrigerator
and freezer sections including doors with
crumpled sheets of black and white
newspaper.
6. Place charcoal briquettes randomly
throughout newspaper.
7. Close doors and let stand 24–48 hours.
8. Remove charcoal briquettes and
newspapers.
9. Complete steps 2–3.
Contact Consumer Affairs Department, if
odor was still not eliminated. Refer to Model
Identification section for phone number.
How to Clean Your Unit
General
1. Wash surfaces with a warm water and baking soda solution. Use a soft clean
cloth to clean surfaces.
2. Rinse surfaces with warm water. Dry surfaces with a soft, clean cloth.
Adhesives
1. Remove glue residue by rubbing toothpaste into adhesive with fingers until
adhesive loosens.
2. Rinse surface with warm water. Dry surface with a soft, clean cloth.
Door Gaskets
1. Keep gaskets clean at all times. Clean door gaskets thoroughly every 3 months
according to "General" instructions.
Condenser Coils
1. Remove toe grille and bottom hinge covers as
shown right.
2. Clean front surface of condenser coil with a vacuum cleaner hose nozzle.
3. Replace toe grille by inserting clips in holes and snapping in. Snap bottom
hinge covers over bottom hinges.
Glass Shelves
1. Dilute mild detergent and brush solution into crevices using a plastic bristle
brush. Let set for 5 minutes.
2. Spray warm water into crevices using faucet spray attachment.
3. Dry shelf thoroughly and replace shelf by inserting hooks into metal track and
lowering front.
16
!
WARNING
!
CAUTION