Koos Isize R1 Installation With The Vehicle Seat Belt; Fasten The Baby Into The Safety Seat - JANE KOOS iSize R1 Manual Del Usuario

G. KOOS iSIZE R1 INST ALLA TION WITH THE VEHICLE SEA T BEL T
The KOOS iSIZE R1 safety seat must be installed FACING THE OPPOSITE
DIRECTION IN WHICH THE CAR IS TRAVELLING. Decide on the seat after
reading the "Choosing where to install the safety seat" section.
To install the seat carefully follow the steps below:
3 .a Position the safety seat on the vehicle seat.
3
.b Pass the seat belt buckle over the baby's feet and fasten it.
3
.c
Insert the abdominal part of the seat belt through the slots (12)
on the sides of the frame.
3 .d The shoulder part of the vehicle seat belt should be passed be-
hind the safety seat.
3 .e Turn the handle (1) to the AUTO position, the furthest forward. The
car symbol on the sides of the handle should be visible.
3
.f Tighten the car seat belt and fasten the locking clip (13). Make sure
that the safety seat is securely anchored by pulling it.
WARNING: For installing rear facing safety seats, the correct guides
!
for fitting the seat belt are marked on the chassis in green. DO NOT
use any belt guide that is not described in these instructions or any
that are not marked green on the baby carrier.
If the safety seat is installed with the ISOfix base (optional), follow the
instructions on the base.
26
EN
H. FASTEN THE BABY INTO THE SAFETY SEAT
Loosen the harness system by pressing the central adjustment button
while carefully pulling the belt fastener.
Unfasten the belt 4 .b and hold the shoulder straps between headrest
and shoulder area. 4 .c
Insert designed for newborn and infants up to 60 cm long.
install the insert, first open the buckle and slide the end of the buckle
through the slot in the insert.
Position the insert so that the back lays flat and the support rests on
4
the bottom. .d Lay the child in the flat wedge. The curved side of
the cushion should be in contac with the bottom of the chair. Do the
opposite to remove the insert.
Cushion seat insert 4 .e. The padding is located in the bag on the
back of the insert, and must be removed for infants longer than 60 cm.
Place the baby in the KOOS iSIZE R1. Pull the straps over baby's shoul-
ders and chest and close the buckle.
To ensure maximum protection, the straps on the KOOS iSIZE R1 car
seat must fit just above the baby's shoulders. Check this height with
the baby seated correctly in the seat.
Your KOOS iSIZE R1 seat has an automatic system for easily adjusting
the straps when adjusting the headrest to your baby's height. Simply
pull and slide the headrest along the backrest to the correct position.
Adjust and correct this height with the baby seated correctly in the
seat 4 .h
4 .a
4 .d
4
.f
4 .g
4
.d . To