Blade Assembly; Testing Your Fan - Craftmade Piccolo PI30AW Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and align
holes. Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat procedure
for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are installed
with blade arm screws, discard plastic motor locks
(save blade arm screws and lock washers to secure blade
arms). Align blade arm holes with motor screw holes
and attach blade arm with lock washers and blade arm
screws. Before securing screws permanently, repeat
procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.

9. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF
position (no blade movement). First pull will set the
fan to HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting (diagram 1). If
fan does not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to end of the pull
chain.
plastic
motor
lock
lock washers
blade arm
screws
reverse
switch
diagram 1
diagram 2
page 7
motor housing
blade attachment
screws and washers
blade
blade arm
motor housing
fan pull
chain
extension
diagram 3 diagram 4