JBM 53684 Manual De Instrucciones página 12

3. Attach the base side supports (27) to the
frame and base support using the bolts (25),
washers (17) and nuts (18). [FIGURE 2]
[FIGURE 2]
5. Attach the pump (43) to the frame using the bolts
(19) (25), washers (20) (17) and nut (18). Attach the
spring (47) of pedal set using the bolt (15). Attach
the pedal using the connecting bolt (49), nut (21),
washer (20) and nut (51). Attach the pedal set to
handle using bolt (21), nut (44) and nut (45). Attach
pump cover (41) to the pump using bolts (42) and
washers (53). [FIGURE 4]
[FIGURE 4]
OPERATING INSTRUCTIONS
Read the IMPORTANT SAFETY INFORMATION section at the beginning of this document,
including all text under the subheadings, before installing or using this product.
Bleeding the Pump
IMPORTANT! Before using for the first time, check that the hydraulic oil level of the pump is
adequate. Then test the piston and pump to see if they work properly before actual use. If the
operation of the pump feels spongy, or the piston lowers while the discharge valve is closed, there
may be air in the pump. Purge the pump as follows:
1. Remove the oil filler screw. The gasket ring should come loose with it.
4. Attach the Winch (14) to the frame using
bolts (19), washers (20) and nuts (21).
[FIGURE 3]
[FIGURE 3]
[FIGURE 5]
· 12 ·
6. Attach the hose to the
ram coupler using the O-ring
(31). Then, attach the gauge
(40) using O-ring (37). Place
the arbor plates (12) on the
press table. [FIGURE 5]
REF. 53684