JBM 53684 Manual De Instrucciones página 11

REF. 53684
SPECIFICATIONS
Capacity (T) Stroke (mm)
30
Ram
Upper Beam
Press table
Hand Winch
(30T and 50T)
Frame Post
Base Support
ASSEMBLY INSTRUCTIONS
Read the IMPORTANT SAFETY INFORMATION section at the beginning of this document,
including all text under the subheadings, before installing or using this product.
Inspect the tool before use for damaged, loose, or missing parts. If a problem is found, do not use
the tool until it is repaired.
The components of this shop press are heavy. You will need an assistant to assemble this product
safely.
Using the components (page 5) and the parts list and assembly diagram near the end of the ma-
nual, place and identify all parts before assembly.
1. Wear safety goggles and heavy leather boots.
2. Put frame (1) in the upright. Slide each base
support (26) under the frame. Align the screw holes
and insert them (24) through the base frame and
support, then secure in place with washers (28) and
nuts (29). [FIGURE 1]
Working Range (mm)
160 166-1126
Bed Width (mm)
540
Gauge
Pump
Pedal
[FIGURE 1]
· 11 ·
Side Stroke (mm)
200
WARNING
1. Do not overextend the
Ram (do not overreach
the warning line).
2. Do not overreach the
loading capacity.
3. Do not attempt to
operate pump unless
the breather valve both
on pump and gauge
are open. Do not press
unless the Hand Winch is
released.
4. Do not press unless the
Hand Winch is released.