Turning On/Off; Charging Batteries - Bosch BSL 2470 Instrucciones E Manejo

18 de fr en fi p t nl sv it es
..3. Operation
!
The cable lengths and the cable cross section
of the charger's cable must not be altered in
any way. The original battery charger cable
must always be connected.

Before connecting the battery charger to
the mains supply, switch the mains switch
on the battery charger to „0" (OFF).

Unscrew the cell plugs on standard batte-
ries before starting the charging process.

Switch the battery charger off before
connecting/disconnecting the charger's
crocodile clip-on terminals.

Never disconnect them while a charging
process is underway.

The battery must not be disconnected from
the vehicle's electrical system for as long
as the charging process is underway.

Never short circuit the charger's crocodile
clip-on terminals.
3.2

Turning on/off

i
The voltage supply for the battery charger is
taken from the lighting line. The device is set
ex-factory to 230 V ± 10 %, 50 Hz.
BSL 2470 is switched on and off using the
power switch.
1 689 979 848 (2005-06-14)
3.3

Charging batteries

i
The charge voltage will remain switched off
at reverse polarity and a short circuit of the
terminals.
i
During the charging process the battery does
not have to be separated from the vehicle's
electrical system.
!
In order to avoid any excessive build up of
gas, you should only conduct the charging
process with the switch set to „hot battery"
at ambient temperatures > 15 °C and for
older batteries. If charging is conducted with
the switch set to „cold battery" however, the
charging process must be stopped immedia-
tely the battery is fully charged..
Adhere to the following procedure when
charging batteries:
1. Switch the battery charger off (Fig. 2,
Pos. 9).
2. Unscrew the cell plugs on standard batte-
ries before starting the charging process.
3. Connect the crocodile clip-on terminals
to the proper battery terminals (Fig. 1,
Pos. 1). The red-colored clip goes to the
positive terminal (+) and the blue one to
the negative terminal (-).
4. Set the two-way switch for „cold and hot
batteries" to the correct position (Fig. 2,
Pos. 6). Note that only the battery tempe-
rature is to be evaluated.
5. Turn the potentiometer for setting the
battery charging current (Fig. 2, Pos. 8)
to the left-hand maximum limit (lowest
charging current).
6. Set the two-way switch (Fig. 2, Pos. 5) to
the specified battery nominal voltage for
the battery to be charged.
BSL 2470
Robert Bosch GmbH