Important - Craftmade Artistry AY56 Instrucciones De Instalación

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Preparation
Important: When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death. To
reduce the risk of shock, this fan must be installed with
an isolating wall control/switch.
2
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
IMPORTANT: If using the angle mount
method, check to make sure the ceiling
angle is not steeper than 35 º . Angles greater
than 35 º will require a 45 º angle adapter.
3
Step 3
Check to make sure blades are
at least 30" from any
obstruction. Check downrod
length to ensure blades are at
least 7' above the floor.
All manuals and user guides at all-guides.com
Downrod Installation
(Normal Ceilings)
Downrod Installation
(Vaulted Ceilings)
30"
0.75m
Min.
84"
(2.1m)
Min.
4
Prior to securing mounting bracket, screw "J" hook (S11) into ceiling
outlet box as a secondary support means. Secure mounting bracket (#1)
to the outlet box (A) by tightening bracket screws & washers (S3) as
shown. If not mounting to an outlet box, use wood screws (S1) and
washers (S3) and mount securely to ceiling beam. Be sure at this point
to insert canopy screws (S2) in bracket.
sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S11)
Ceiling
Bracket Screws
& Washers (S3)
Wood Screws (S1)
Canopy Screws (S2)
5
Step 5
Locate downrod assembly
(#2). Loosen ball screw on
black hanging ball to free
lock pin. Black hanging
ball will slide down.
Remove ground screw and
green ground wire. Remove
hanging ball from downrod
and save all parts. Insert fan
wires through downrod.
Attach downrod accessory
to downrod and secure
with downrod accessory
screws. Screw downrod into
top of fan motor housing,
being careful that wires are
pulled through.
Step 4
NOTE: Do not mount directly to
Support Beam
Outlet Box (A)
OUTLET BOX
Mounting Bracket (1)
Wood Screws (S1)
Lock Pin
Green Ground
Wire
Ball Screw
Hanging Ball
Downrod
Downrod
Accessory Screw
Downrod
Assembly
(#2)
Downrod
Accessory
Downrod
Accessory Screw
Fan Motor Housing
Tabla de contenido
loading

Tabla de contenido