Craftmade Artistry AY56 Instrucciones De Instalación página 4

6
Step 6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S8) through coupling and
downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Replace switch housing cover (6) by placing it over the
downrod and plugging in the black antenna wire. Rest the switch cover
on the motor housing (7) and turn firmly clockwise until secure. Place
canopy (3) over downrod (#2). Replace hanging ball, insert hanging pin
through downrod and tighten set screw "C" in hanging ball into
downrod.
Threaded Set
Screw Hole
Ground
Hanging
Wire
Pin
Hanging Ball Screw
Ball
WARNING: Failure to completely
tighten downrod as described in steps
5 & 6 above could result in the fan
loosening and possibly falling.
Safety Bolt
and Nut
IMPORTANT: Black
antenna wire must be
connected for fan to
function.
All manuals and user guides at all-guides.com
Set Screw (C)
Downrod (2)
Canopy (3)
Downrod
Accessory
Switch Housing
Cover (6)
Set Screw (A)
Motor Housing (7)
7
For added security, attach safety cable from fan unit to "J" hook (S10) in
outlet box. Secure by looping zip tie (S11) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for
click).
Green Ground Wire
NOTE: Parts furnished will allow you to install your fan at up to a 35 º angle. Angles
greater than 35 º will require a 45 º angle adapter (see dealer).
NOTE: J Hook installation is a Canadian requirement only.
WARNING: To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
Step 7
Support Beam
"J" Hook (S10)
Outlet Box (A)
OUTLET BOX
Ceiling
Mounting Bracket (#1)
"J" Hook (S10)
Zip Tie (S11)
Safety Cable