Electrical Installation - SICK CQF16 Instrucciones De Operación

6

Electrical installation

8022690 | SICK
Subject to change without notice
Installation possibilities
Table 1: Installation options
Figure 4: Velcro installation
position on a tank
Figure 7: Adhesive mounting
Figure 9: Flush mounting, fig.
1
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: Note pin assignment – Cable: Wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanations on connection diagram:
NC = normally closed
NO = normally open
MOUNTING AND INSTALLATION
Figure 5: Bracket on thin
pipe
Figure 8: Adhesive mounting
Figure 10: Flush mounting,
fig. 2
> 0 V) once all electrical connec‐
V
Figure 6: Mounting with
cable ties on a pipe
Figure 11: Flush mounting,
fig. 3
= 0 V). The following informa‐
V
5
7