Installation Notes; Electrical Installation - SICK CMB Serie Instrucciones De Uso

5

Electrical installation

8027571/2022-03-07 | SICK
Subject to change without notice

Installation notes:

CMB18-08B / CMB30-16B:
d
d d
Figure 1: Installation conditions, flush installation variants
CM18-12N / CMB30-25N:
3 x d
1
d
1
1
Figure 2: Installation conditions, non-flush installation variants
CMB18: 8 mm
1
CMB30: 14.5 mm
Operation in standard I/O mode:
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
NOTE
Strain relief for the connecting cable should be installed as close as possible to the
sensor.
Only apply voltage and switch on the voltage supply once all electrical connections have
been established.
Explanation of the connection terminology used in the following tables:
BN = brown
WH = white
BU = blue
BK = black
n. c. = not connected
OPERATING INSTRUCTIONS
3 x d
1
d
1
O P E R A T I N G I N S T R U C T I O N S | CMB
en
21