Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LDA3B /LDA3BCP Commercial Recessed Adjustable LED
OPTICS
1.
To remove optic, twist gently counter-clockwise. To
replace, push optic and twist gently clockwise until it
"clicks" (see Figure 5).
2.
Also available, is a single/double media holder. To install,
place the media onto the media holder. Engage snaps
at bottom of snap staircase. Twist clockwise until tight
(see Figure 6).
Twist counter-clockwise
REMOVAL
Figure 5
Snap and twist
clockwise
Figure 6
AIMING
1.
This fixture allows for 365-degree rotational "aim" . Due
to the small opening, it is recommended you remove
the optic to perform this operation.
2.
Loosen the rotation lock down screw using a Phillips
No. 2 screwdriver (see Figure 7a).
3.
Turn the mechanism to the desired position using the
positioning tab and a screwdriver (see Figure 7b).
4.
Tighten the rotation lock-down screw to secure the
desired position. (Do not over-torque) (see Figure 7a).
5.
Replace optic upon completion.
4
PORTFOLIO
IB520076ML
Push up and twist clockwise
to tighten
INSTALLATION
Media holder
Installation instructions
Figure 7a
Figure 7b
Figure 7c
Tabla de contenido
