Panasonic TY-ST65VX100 Instrucciones De Instalación página 4

Attaching the pedestal to the display
For setting up the pedestal, refer to the operating instructions of plasma display.
1
Attach the plasma display to the
pedestal.
Arrow marks are displayed on the back cover at the
locations shown below.
Align the stand pins
the plasma display.
2
Attach the stand poles.
(1) Insert the two stand poles
from the rear of the plasma display, and then
use the stand pole fi xing screws
stand poles
• The stand poles
(2) Use the four stand pole display fi xing screws
secure the stand poles
Attaching the light-blocking panel
1
Prepare the light-blocking panel.
(1) Place the light-blocking panel
sheet facing upward.
(2) Fold over the portion of the panel with notches
and holes in it along the crease. (See illustration.)
2
Attach and secure the light-blocking
panel.
(1) Slightly bend the light-blocking panel to form
a U-shape and fi t the ends into the gaps (right
and left) between the stand pins and the plasma
display. Align the notches in the light-blocking
panel with the stand pins.
• The cloth sheet side should be facing the rear
panel of the plasma display.
(2) Align the four holes in the light-blocking panel
with the holes in the stand base, insert the (four)
fi xing pins
the fi xing pins to lock them in place.
4
with these arrows, and install
into the stand base
to secure the
.
have a front and back.
and plasma display.
with the cloth
, and push down hard on the tops of
Rear
to
B
1
Cloth sheet
H
2
C
B
Notch
H
D
Front
H
1 2
H
F
B
F