Starting The Dell Diagnostics From The Optional Drivers And Utilities Cd - Dell Latitude D810 Guía De Instalación Y De Referencia Rápida

5 Use the down-arrow key to select Diagnostics and press <Enter> to start the Dell
Diagnostics from the diagnostics utility partition on your hard drive.
NOTE:
If the boot device list does not display and the screen is blank, press the <End> key. Then press
the <Enter> key to begin the Dell Diagnostics.
The computer runs the Pre-boot System Assessment, a series of initial tests of your system
board, keyboard, hard drive, and display.
• During the assessment, answer any questions that appear.
• If a failure is detected, the computer stops and beeps. To stop the assessment and restart
the computer, press <n>; to continue to the next test, press <y>; to retest the
component that failed, press <r>.
• If failures are detected during the Pre-boot System Assessment, write down the error
code(s) and contact Dell before continuing on to the Dell Diagnostics.
If the Pre-boot System Assessment completes successfully, you receive the message
Dell Diagnostic Utility Partition. Press any key to continue
6 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard
drive.

Starting the Dell Diagnostics From the Optional Drivers and Utilities CD

1 Insert the Drivers and Utilities CD.
NOTE:
The Drivers and Utilities CD is optional and may not ship with all computers.
2 Shut down and restart the computer.
When the DELL logo appears, press <F12> immediately.
If you wait too long and the Windows logo appears, continue to wait until you see the
Windows desktop. Then shut down your computer and try again.
NOTE:
The next steps change the boot sequence for one time only. On the next start-up, the computer
boots according to the devices specified in system setup.
3 When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.
4 Select the CD/DVD/CD-RW Drive option from the CD boot menu.
5 Select the Boot from CD-ROM option from the menu that appears.
6 Type
to start the ResourceCD menu.
1
7 Type
to start the Dell Diagnostics.
2
8 Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed,
select the version appropriate for your computer.
9 When the Dell Diagnostics Main Menu appears, select the test you want to run.
22
Quick Reference Guide
Booting
.