Light Kit Assembly (Optional) - Craftmade Kate Guia De Instalacion

9. Light Kit Assembly (Optional).

If you wish to use your fan WITHOUT the light
kit, remove 3 screws from switch housing cap.
Align holes in switch housing cap with holes in
switch housing. (Note: Gap on edge of switch
housing cap must align with reverse switch in
switch housing for the proper fit.) Secure switch
housing cap with 3 screws that were previously
removed. Please proceed to Section 10 on the
following page to complete installation without
light kit. [Refer to diagram 1.]
If you wish to use your fan WITH the light kit,
locate BLACK (or BLUE) and WHITE wires in
switch housing labeled LIGHT. Remove and
discard plastic that holds these 2 wires together.
Remove 3 screws from switch housing cap.
Remove hex nut and lock washer from threaded
rod on light kit fitter. Punch center cap out of
switch housing cap with a screwdriver. Feed
wires from light kit fitter through center hole in
switch housing cap, and then screw switch
housing cap onto threaded rod followed by the
lock washer and hex nut. Tighten hex nut over
lock washer for a secure fit. [Refer to diagram 2.]
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLACK
(or BLUE) wire from switch housing to BLACK
wire from light kit fitter. Be sure that molex
connections snap together securely.
Align holes in switch housing cap (at top of light kit
fitter) with holes in switch housing
fitter to switch housing with 3 screws that were
removed. Secure all 3 screws with Phillips
screwdriver.
Remove socket rings from light kit fitter. Use
socket ring to attach shade.
WARNING: Do NOT overtighten socket rings.
Install 3 medium base 4 watt LED bulbs
(included).
Important: When you need to replace bulbs,
please allow bulb(s) and shade to cool down
before touching them.
[Refer to diagram 3.]
switch housing
diagram 1
diagram 2
. Attach light kit
switch housing cap
socket ring
diagram 3
page 8
cap
switch housing cap
hex nut
lock washer
black
(or blue)
black white
socket ring
bulb
motor
housing
switch
housing
center cap
switch housing cap
light kit fitter
switch housing
white
molex
connections
light kit
fitter
shade