Standard Accessories; Optional Accessories - Tannoy CMS 3.0 Serie Manual Del Usuario

14
CMS 3.0 Series
Accessories

Standard Accessories

C-Ring
Grille
Paint Mask

Optional Accessories

Plaster (mud) ring
Installation Guide for Suspended Ceilings
1. Remove the ceiling tile from its frame and place it on a flat surface. Position the cutout template
(self adhesive backed) on the tile. (Fig.1)
Tile-bridge kit
Note: A tile-bridge kit
must always be used
when installing into
suspended ceiling tiles
2. Cut out the hole in the ceiling tile using a pad saw following the broken line indicated on the template (Fig.2)
Cut-out template
3. Place the C-Ring and tile-bridge on top of the ceiling panel, aligning the C-Ring over the hole, and screw the
C-Ring to the tile bridge using the fixings provided. (Fig.3)
4. Go to the 'Wiring and Setting Up' chapter.
5. Slide the speaker assembly through the hole. Turn the screws (denoted "Screw Fix") clockwise on the front of
the speaker to extend the mounting wings. Tighten the screws until a firm grip is achieved. (NOTE: Screws have
a PoziDriv head; use of a PoziDriv driver is recommended). If using a power driver, Tannoy recommends a torque
setting of 1.5 Nm. (Fig.4)
DO NOT OVERTIGHTEN!
60 W Transformer
Note: For use with CMS
803 PI in distributed lines 6. Attach the nylon safety to the hooks on the front baffle before attaching the grille by presenting it to the
speakers and allowing the magnets to pull it into position (Fig.5). (With the CMS 403DCe/ICTe, the grille is
without backcans.
already fitted to the product.)
NOTE ON INSTALLATION OF CMS 403DCe/ICTe:
Before tightening the screws in step 5, swivel the speaker in the desired direction. When the screws are tightened, the speaker will lock into position. Replace the front
trim to conceal the mounting screws.
15
Quick Start Guide
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5