Festo CPX Serie Breve Descripción página 16

CPX fieldbus node/CPX-FEC
CPX fieldbus node or CPX-FEC
with Remote I/O operating
mode:
– "System start" system
parameter ( [System start] ):
"System start with default
parameterisation and current
CPX expansion"
( [Default parameters] ),
factory setting
CPX fieldbus node or CPX-FEC
with Remote I/O operating
mode:
– "System start" system
parameter ( [System start] ):
"System start with saved
parameterisation and saved
CPX expansion"
( [Saved parameters] )
CPX-FEC with Stand Alone or
Remote Controller operating
mode
16
Accepting the address range
The modified address range of the
CPX-CP interface is automatically
accepted.
1. Change system parameter
"System start ..." to " ... Default
parameterisation ..." .
2. Switch off the power supply of
the CPX terminal then switch it
on again. The address range of
the CPX-CP interface will then
be accepted.
3. If necessary, you can restore
the desired parameterization.
• To accept the address range of
the CPX-CP interface, the actual
configuration must be saved as
the nominal configuration
(nominal/actual comparison).
Further information can be found
in the manual for the CPX-FEC or
the manual for the FST 4.1 soft-
ware package.
Festo CPX-CP-4-FB-Z6 1212a English