Kohler Sterling 7626 Serie Guia De Instalacion página 17

3/4" (1.9 cm) Plywood
12. Place the Whirlpool Bath on the Subfloor
Make sure there is a drop cloth or other protective liner in the whirlpool.
Verify that the studs are within 1/8" (3 mm) of the whirlpool at the recommended support clip
locations. Shim if necessary.
Position the bottom lip of the attachment clip under the edge of the whirlpool and place the tab
against the bath flange.
Drill pilot holes through the flange at the attachment clip locations to protect the flange from
cracking when the fasteners are installed.
Slide the attachment clip into place between the center of the stud and the whirlpool.
NOTE: If galvanized roofing nails will be used, use caution when hammering to avoid striking the
whirlpool.
Secure the attachment clips with galvanized or plated non-tapered flathead screws.
Sterling
Attachment Clip
18-3/4"
(47.6 cm)
13/16" (2.1 cm)
5-1/4" (13.3 cm)
Section at Drain End
Flange
Screw
2-1/2" (6.4 cm) D. Overflow
16-1/2" (41.9 cm)
17"
2" (5.1 cm)
(43.2 cm)
D. Drain
17
Flange
Attachment Clip
1105582-2-B