Kohler Sterling 7626 Serie Guia De Instalacion página 14

9. Position the Whirlpool - Alcove Installations
Alcove Installations
CAUTION: Risk of product damage. Do not lift or move the whirlpool by the apron or apron
braces. Verify that the apron braces are attached before installing the whirlpool, then lift the
whirlpool by the rim at multiple points.
Install the drain and overflow assembly to the whirlpool according to the drain manufacturer's
instructions. Do not connect the trap at this time.
NOTICE: Verify that the apron braces are attached before installing the whirlpool.
If a mortar cement bed is not present, position the felt pad under the whirlpool supports.
Position and adjust the whirlpool until its outside edge is flush with the framing.
Verify that the whirlpool is level and well supported by the subfloor. If whirlpool is not level, shim
the whirlpool using metal, hardwood, or other durable material.
Reposition and shim the whirlpool until it is aligned with the finished wall and is level.
Position the supplied liner in the whirlpool to protect the finish. If the protective liner is not
available, add a drop cloth or other protective liner.
Install a Mortar Cement Bed (Optional)
NOTE: If a mortar cement bed will be installed, the pad is not required.
Remove the whirlpool and pad from the alcove.
NOTE: Do not use plaster, gypsum cement, or drywall compound for this application, as they will not
provide adequate structural support.
NOTE: The whirlpool supports must rest directly on the subfloor.
Build a dam to keep the flooring material clear of the drain area.
Spread a 2" (5.1 cm) layer of mortar cement on the subfloor, spreading it so that each area of the
whirlpool that will contact the subfloor has mortar cement. Do not spread the mortar cement
around the drain area. Allow room for the mortar cement to expand from the weight of the
whirlpool.
Immediately move the whirlpool into position.
Verify that the whirlpool is level and resting on all supports.
Clean the whirlpool to reduce the risk of damaging the surface.
1105582-2-B
Verify level.
Studs
Shim if necessary.
14 Sterling